Castle Creation Speed Controls

	Castle Creation Brush Speed Controls a small manufacturer of speed controls, Castle Creations believes in providing state-of-the-art technologies in it's product designs.	Shopping Cart You have 0 items in your Shopping Cart $0.00

Castle Creations Pixie 7P
Programmable Sub Micro Motor Control
Programmable! Ideal for 3 or 4 cell NiCad/NiMH or Lithium packs.

An updated version of our original Pixie-7, the Pixie-7P provides modelers flexibility through the use of user-programmed features. Using an on-board LED and your throttle stick, you decide the cut-off voltage, motor cut-off, and throttle range options on this ESC!

The Pixie-7P can be used with Speed-280 and smaller motors where current draw will be 7 amps or less. It comes with custom-made 24 gauge silicone wire for battery and motor leads.

The Pixie-7P can be set up for lower cut-off voltages for 3 or 4 cell NiCad packs, higher cut-offs for lithium cells or 10-16 cell NiCad packs, or no cut-off for micro helis. The unit comes pre-programmed for standard 5-10 cell aircraft operation (4.7V cut-off).

Specfications
Cells with BEC	3-8
Cell with out BEC	3-18
Continous	7 amps
Surge	10 amps
Switching Rate	2800 HZ
Resistance	0.007 ohms
Brake	No
Reversable	No
Low Voltage Cutoff	Programmable
Size	0.28x0.58in
Weight	.11oz

Castle Creation Pixie 20P
Programmable Sub Micro Motor Control
THE Choice of Speed-400 Flyers!
Featuring a continuous current rating of 20 amps, the Pixie-20P is remarkably small and light. Just 0.4" x 0.7" (smaller than most "indoor" controls) the Pixie-20P is small and light enough to be used in the lightest indoor models, but has the current capability to handle hot Speed-480 pylon racers. The Pixie-20P features a full 1.25A BEC for use with up to three servos. Now with programmable cut-off, the Pixie-20P can be set to get full use of your pack. Five cut-off choices allow the Pixie to be used with Lithium cells.

Specfications
Cells with BEC	5-10
Cell with out BEC	5-18
Continous	20 amps
Surge	30 amps
Switching Rate	2800 HZ
Resistance	0.0025 ohms
Brake	No
Reversable	No
Low Voltage Cutoff	Programmable
Size	0.7x0.4in
Weight	.3oz

Castle Creations Sprite-25 Speed Control
Lighten up with the smallest full-featured 25 amp speed control available! The tiny microprocessor-based Sprite-25 with BEC and Brake was designed for Speed-400 sailplanes and low-current, general purpose flying. Works great with hot wind motors like the AP-29BB and the Speed-480. The Sprite-25 also works well with many 05 (non FAI) motors.

Specfications
Cells with BEC	5-10
Cell with out BEC	5-16
Continous	25 amps
Surge	40 amps
Switching Rate	2800 HZ
Resistance	0.0025 ohms
Brake	Yes
Reversable	No
Low Voltage Cutoff	4.7 volts
Size	0.9x0.7in
Weight	.5oz

Castle Creations Pegasus-35 Speed Control
The Pegasus-35P is a rugged surface mount speed control designed for the sport flyer. The Pegasus-35P can handle ferrite and many cobalt motors. The Pegasus-35P features a choice of cut-off voltages easily set using your throttle stick. And, it's smaller and lighter than most Speed-400 controls!

With it's user-programmable features, the all new Pegasus-35P can be set up for either aircraft or helicopter installations. Settings are permanently stored until you change them!

Need a brake..check out the Griffin-40

Specfications
Cells with BEC	5-10
Cell with out BEC	5-18
Continous	35 amps
Surge	60 amps
Switching Rate	2800 HZ
Resistance	0.0015 ohms
Brake	No
Reversable	No
Low Voltage Cutoff	programmable
Size	1.1x0.6in
Weight	.75oz

Castle Creations Griffin-40
The perfect ESC for ferrite and mild cobalt motors, the Griffin-40 is ideal for sport flyers that need a prop brake. Features a dual BEC circuit for added security in high cell/servo installations. The Griffin is an excellent sailplane ESC.

Don't need a brake? See the new Pegasus-35P.

Specfications
Cells with BEC	5-10
Cell with out BEC	5-16
Continous	40 amps
Surge	60 amps
Switching Rate	2800 HZ
Resistance	0.0012 ohms
Brake	Yes
Reversable	No
Low Voltage Cutoff	4.7 volts
Size	1.4x0.6in
Weight	.9oz

Castle Creations Griffin-55M
Leave your competition in the dust! Whether you are flying a class B LMR glider or a high-power sport plane like the CSD Vortex, the Griffin-55 can handle it. The Griffin-55 is a high current micro motor control designed for FAI class cobalt motors.

Specfications

Cells with BEC 5-10

Cell with out BEC 5-16

Continous 55 amps

Surge 80 amps

Switching Rate 2800 HZ

Resistance 0.001 ohms

Brake Yes

Reversable No

Low Voltage Cutoff 4.7 volts

Size 1.4x0.6in

Weight
1oz